![]() So I am going to click on my Signal Generator, and I will be using Output 1. I am now ready to go set up my signal generator. So I am going to add my two Voltage Sensors. I can do that by clicking on the channel, typing the first few letters of the sensor, and then confirming it with the Enter button. I am going to begin by going to my Hardware Setup and adding my two Voltage Sensors. Now let's take a look PASCO Capstone and getting set up inside of our software. And my signal generator is attached across the entire circuit. In Channel B, I have a Voltage Sensor measuring the voltage across my second resistor. Connected to my 850 interface, in Channel A I have a Voltage Sensor measuring the voltage across the entire circuit. ![]() On the circuit board I am going to be using the first inductor component, the first capacitor component, and the second resistor component. I am going to be using the UI-5210 circuit board. Let's begin by taking a look at our LRC circuit setup. In this video, we are going to take a look at an LRC setup with PASCO Capstone and the 850 Universal Interface.
0 Comments
Leave a Reply. |